Here's another prop that's in the Dress-Up Box - a ribbon ring/
ribbon loop/ring with streamers. I'm sure it has a proper name
but I don't know what it is.
Anyway, it's one of those things that toddlers in music-and-movement
classes hold and wave about as they experience rhythm and motion.
Like Emily at one of the outdoor summer activities organized by the
city's parks and recreation department:
They can be bought but they can be made for less. Plus, they are a
good way to use up the odd remnants in one's ribbon stash.
And because they were so simple and fast to make, here's a tutorial.
What you need:
- 1 yard of each ribbon, all of the same width, and at least 1" wide. Satin is a nice choice but it's more expensive. I used 1" grosgrain because it was what I had a lot of. They tend to be heavier and less floaty than the thin polyester streamers the commercial ribbon rings come with but they still swish about nicely.
- 11" of nylon strap - the sort that duffle bags come with. The width of the strap should be twice that of the ribbon. Mine was 2".
- Candle or other open flame
- Sewing machine
- Light the candle.
- Take one ribbon and singe one end to prevent fraying. To do this, hold the end about an inch above the flame as shown. Move it horizontally sideways so that the flame singes the entire width. If nothing happens, lower the ribbon edge slightly and repeat. If the end melts and distorts, you're too close! Snip off the bad bit and start again.
- Repeat for all the ribbons. Remember, you are going to singe only one end - these will be the exposed ends of the ribbon-streamers. The other end of each ribbon will be tucked into the strap-loop and doesn't need to be singed.
- Now find all the un-singed (i.e. still fraying) ends of the ribbons and stack them together as shown.
- Take the nylon strap and fold it in half lengthwise. You may need to hold it down and press hard on the crease to make it stay folded.
- Sew a line of stitches close to the open edge to secure it in folded position permanently.
- Backstitch on both ends.
You now have a double-thickness, half-width nylon strap.
It doesn't matter if it's slightly curved -
it will straighten itself out in the next step.
- Lay this "sandwich" flat and sew a square of stitching to secure it. In the picture below, the white square shows where to sew. Make the square (or rectangle) long enough so that the fraying edges of the ribbons are enclosed within the square (or rectangle).
I'm guessing that it is possible to use fabric stiffened with interfacing
to make the strap, in place of the nylon strap. However, I like the
nylon strap because it is malleable and keeps it shape - it can be
pressed out long and flat so that it's like a stick, or opened up
in a loop for little hands to hold.
You could also use a cotton strap - it holds its shape just as well
but you can't singe it to prevent fraying.
You'd have to serge the edges or use bias tape.
The completed ribbon ring/loop.